LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Venza 2.7 E, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1AR-FE) - System Testing, Removal & Installation >> Relay >> On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT IG2 RELAY 
    1. Remove the IG2 relay from the relay block.
    2. Measure the resistance according to the value (s) in the table below.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      3-5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
      3-5 Battery voltage Is applied across terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.

      Fig 1: IG2 Relay Circuit Diagram
      G05302308Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals