LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Venza 2.7 E, AWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield/Window Glass >> Power Window Control System >> DTC B2313 Glass Position Initialization Incomplete >> Inspection Procedure

Inspection Procedure

NOTE:
  • When the power window regulator motor assembly is reinstalled or replaced, the power window control system must be initialized.
  • After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be reinitialized by repeating the following operations at least 5 times:
    1. Close the power window by fully pulling up the power window regulator master switch assembly or power window regulator switch assembly and holding it at the auto up position.
    2. Open the power window by fully pushing down the switch.
  1. PERFORM INITIALIZATION (APPLICABLE LOCATION) 
    1. Turn the ignition switch to ON.
    2. Initialize the power window regulator motor assembly (See INITIALIZATION  ).

      HINT:

      Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

  2. CHECK DTC OUTPUT 
    1. Turn the ignition switch off.
    2. Wait for at least 10 seconds, and then turn the ignition switch to ON.
    3. Check for DTCs (See DTC CHECK / CLEAR  ).

      HINT:

      Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

      OK: B2313 output does not recur  .

      Result 

      RESULT CHART

      Result Proceed to
      OK A
      NG (Driver side power window) B
      NG (Front passenger side power window) C

      B: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)  (See REMOVAL  )

      C: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)  (See REMOVAL  )

      A: END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

scientia non olet · About LEMON Manuals