Inspection Procedure

NOTE: When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION ).

REPLACE ECM
1. Replace the ECM for 1GR-FE (See REMOVAL ), (See REMOVAL 2UZ-FE) or (See REMOVAL 3UR-FE).

RECONFIRM DTC

Clear the DTC (See DTC CHECK/CLEAR ).

Check if the same DTC is output (See DTC CHECK/CLEAR ).

Result

RESULT TABLE

Result	Proceed to
DTC is output	A
DTC is not output	B

B: END

A: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )