Rear Speed Sensor: Installation

INSTALL SKID CONTROL SENSOR WIRE
1. Install the sensor clamp with the nut (labeled A).
  Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
  
  NOTE: Make sure the clamp's rotation stopper touches the installation position.
2. Install the sensor clamp with the bolt (labeled B).
  Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
  
  NOTE: When installing the clamp, do not twist the wire harness.
3. Attach the 7 clips (labeled C).
  NOTE:
  - When installing the clamps, do not twist the wire harness.
  - When installing the clamps, securely insert them as shown below.
4. Connect the sensor connector (labeled D).
  NOTE: Securely connect the connector.
  
  Fig 1: Locating Sensor Clamp With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SPEED SENSOR LH
1. Install the speed sensor (labeled A) with the nut (labeled B).
  Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf)
2. Connect the speed sensor connector (labeled C).
  NOTE: Securely connect the connector.
  
  Fig 2: Locating Rear Speed Sensor With Nut (LH)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SPEED SENSOR RH
1. Install the speed sensor (labeled A) with the nut (labeled B).
  Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf)
2. Connect the speed sensor connector (labeled C).
  NOTE: Securely connect the connector.
  
  Fig 3: Locating Rear Speed Sensor With Nut (RH)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WHEEL
Torque: for Aluminum Wheel

131 N*m (1336 kgf*cm, 97 ft.*lbf)

for Steel Wheel

209 N*m (2131 kgf*cm, 154 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
CHECK SPEED SENSOR SIGNAL
1. Check the speed sensor signal (see TEST MODE PROCEDURE ).