Transfer Assembly: Installation

INSTALL TRANSFER ASSEMBLY
1. Install the transfer assembly with the 8 bolts.
  Torque: 24 N*m (244 kgf*cm, 17 ft.*lbf)
  
  NOTE: Take care not to damage the adaptor rear oil seal with the transfer input gear spline.
  
  Fig 1: Installing Transfer Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL MANUAL TRANSMISSION ASSEMBLY (for R155F)
(See INSTALLATION )
INSTALL MANUAL TRANSMISSION ASSEMBLY (for RA60F)
(See REMOVAL )
INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for A750F)
(See INSTALLATION )
INSTALL TRANSFER CASE LOWER PROTECTOR
1. Install the 4 bolts and the transfer case lower protector.
  Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
  
  Fig 2: Locating Transfer Case Lower Protector And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD TRANSFER OIL
INSPECT TRANSFER OIL (See TRANSFER OIL )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
CHECK FOR TRANSFER OIL LEAKAGE
CHECK FOR EXHAUST GAS LEAKAGE