LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Sienna XLE Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Audio/Visual) >> Radio Receiver >> Removal

Radio Receiver: Removal

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH  (See REMOVAL )
  2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH  (See REMOVAL )
  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  6. REMOVE RADIO RECEIVER WITH BRACKET 
    1. Remove the 4 bolts.
      Fig 1: Locating Radio Receiver Bracket Bolts
      G06010542Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the radio receiver with bracket toward the rear of the vehicle and disengage the 4 clips.
    3. Disconnect each connector and remove the radio receiver with bracket.
    Fig 2: Identifying Radio Receiver Bracket Clips
    G06010543Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 4 screws and No. 2 radio bracket.
    Fig 3: Locating No. 2 Radio Bracket Screws
    G06010544Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 4 screws and No. 1 radio bracket.
  9. REMOVE RADIO RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals