Inspection Procedure
WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the display on the Techstream.
Main Body (Main Body ECU)
DATA LIST REFERENCE
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D-Door Lock Pos SW | Driver side door lock position switch signal/ON or OFF | ON: Driver side door unlocked OFF: Driver side door locked |
- |
| P-Door Lock Pos SW | Front passenger side door lock position switch signal/ON or OFF | ON: Front passenger side door unlocked OFF: Front passenger side locked |
- |
| RL-Door Lock Pos SW | Rear door lock position switch LH signal/ON or OFF | ON: Rear door LH or RH unlocked OFF: Rear door LH and RH locked |
- |
| RR-Door Lock Pos SW | Rear door lock position switch RH signal/ON or OFF | ON: Rear door LH or RH unlocked OFF: Rear door LH and RH locked |
- |
OK:
Normal conditions listed above are displayed.
NG: GO TO POWER DOOR LOCK CONTROL SYSTEM (See PROBLEM SYMPTOMS TABLE )
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )