Section 53 (Charging System (2ZR-FE)): Generator: Installation

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the wire harness clamp bracket with the bolt.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
  
  Fig 1: Locating Wire Harness Clamp Bracket Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the generator assembly with the 2 bolts.
  Torque: Bolt A
  
  43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Bolt B
  
  19 N*m (190 kgf*cm, 14 ft.*lbf)
  
  Fig 2: Locating Generator Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the connector and wire harness clamp.
4. Install the wire harness to terminal B with the nut and install the terminal cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 3: Locating Terminal Cap, Nut And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-RIBBED BELT (See INSTALLATION )
ADJUST V-RIBBED BELT (See INSTALLATION )
INSPECT V-RIBBED BELT (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER RH
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL