Data List / Active Test

HINT:

Using the Data List displayed on Techstream, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the Data List as the first step in troubleshooting is one way to shorten the labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on.
3. Turn the tester on.
4. Enter the following menus: Body Electrical / Immobiliser / Data List.
5. Read the Data List accordign to the display on the tester.

   Transponder key ECU: 

   TRANSPONDER KEY ECU REFERENCE
   
   

   Item	Measurement Item/Display (Range)	Normal Condition
   KEY SW	Unlock warning switch signal / ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder
   IG SW	Ignition switch signal / ON or OFF	ON: Ignition switch on OFF: Ignition switch off
   Immobiliser	Immobiliser system status / SET or UNSET	UNSET: Ignition switch on SET: Without key
   Permit (Start)	Permit (Start) signal / OK or NG	NG: No permission for engine start OK: Engine start permission
   Response	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   Frame Error	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   Different Encrypt Code	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   Abnormal Status	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   Bcc Malfunction	Transponder chip data / NG or OK	NG: Incorrect data being sent. OK: Correct data being sent.
   Sub Key	Sub key code signal / NOMATCH or MATCH	NOMATCH: Non matching sub key code is sent. MATCH: Sub key code is sent.
   Master Key	Master key code signal / NOMATCH or MATCH	NOMATCH: Non matching master key code is sent. MATCH: Master key code is sent.
   Transponder S-Code	Number of registered sub key / min. 0, max. 15	Number of registered sub key.
   Transponder M-Code	Number of registered master key / min. 0, max. 15	Number of registered master key.
   Reg Code Space Full	Memory space for key codes registration / NOT FUL or FULL	NOT FUL: More key code registration possible. FULL: No more key code registration possible.
   +B	Power source / BRAKE or NORMAL	BRAKE: Power source open. NORMAL: Power source normal.
   Antenna Coil Status	Antenna coil condition / NORMAL or FAIL	NORMAL: Antenna coil is normal. FAIL: Antenna coil is malfunctioning.

HINT:

Performing the ACTIVE TEST using Techstream allows the relay, VSV, actuator, etc. to operate without removing any parts. Performing the Active Test as the first step of troubleshooting is one way to shorten labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on.
3. Turn the tester on.
4. Enter the following menus: Body Electrical / Immobiliser / Active Test.

   Transponder key ECU: 

   TRANSPONDER KEY ECU REFERENCE
   
   

   Item	Test Details	Control Range
   Security Indic	Turn security indicator	ON / OFF