Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test
5. Check the CRUISE main indicator light by performing the Active Test.

   METER: 

   METER ACTIVE TEST LIST
   
   

   Tester Display	Test Part	Control Range
   Indicat. Lamp Cruise	Cruise main indicator light	BLINK / OFF

   OK: The indicator light blinks/goes off. 

NG: REPLACE COMBINATION METER ASSEMBLY  (See REMOVAL )

OK: Go to Next Step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. Check the Data List for proper functioning of the CRUISE main indicator light.

   ECM (Cruise control): 

   DATA LIST - ECM (CRUISE CONTROL)
   
   

   Tester Display	Measurement Item/Range	Normal Condition
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off

   OK: When the cruise control main switch is operated, the display changes as shown above. 

NG: REPLACE ECM  (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )