Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH LH
1. Engage the 2 pins and install the steering pad switch LH.
2. Install the screw.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  
  Fig 1: Identifying Steering Pad Switch LH Pins And Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the clamp.
4. Connect the connector to the spiral cable.
Fig 2: Locating Pad Switch Connector With Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 pins and install the steering pad switch assembly.
2. Install the screw.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  
  Fig 3: Identifying Steering Pad Switch Assembly With Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the clamp.
  
  Fig 4: Identifying Steering Pad Switch Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Engage the 2 pins and install the steering pad switch.
5. Install the screw.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  
  Fig 5: Identifying Steering Pad Switch Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Engage the clamp.
7. Connect the connector to the spiral cable.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See DISPOSAL )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See DISPOSAL )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 6: Locating Pad Switch Connector With Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT STEERING PAD (See DISPOSAL )
INSPECT SRS WARNING LIGHT

(See DIAGNOSIS SYSTEM )