Inspection Procedure

1. Disconnect the connector from the television display assembly.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION AND SPECIFIED CONDITION
   
   

   Tester connection	Condition	Specified condition
   GND - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION AND SPECIFIED CONDITION
   
   

   Tester connection	Condition	Specified condition
   +B - GND	Always	10 to 14 V
   ACC - GND	Ignition SW ACC	10 to 14 V

Fig 1: Identifying Television Display Assembly Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE