Inspection Procedure
NOTE:
When replacing the brake actuator assembly, perform the zero point calibration (See
CALIBRATION ).
- PREPARE FOR INSPECTION
- Check that both of the following conditions are satisfied.
- The vehicle is not in VSC OFF mode.
- The vehicle is not in inspection mode.
HINT:
Confirm if the vehicle is in inspection mode or not by using the Techstream Data List.
NEXT
- CHECK CAN COMMUNICATION SYSTEM
- Check if a CAN communication system DTC is output (See HOW TO PROCEED WITH TROUBLESHOOTING ).
Result
RESULT CHARTResult Proceed to DTC is not output. A DTC is output. B NG : REPAIR CAN COMMUNICATION SYSTEM (See DIAGNOSTIC TROUBLE CODE CHART )
OK : Go to Next Step
- INSPECT SKID CONTROL ECU CONNECTOR
- Check if the skid control ECU connector is securely connected.
OK: The connector is securely connected.
NG : CONNECT CONNECTOR CORRECTLY
OK : Go to Next Step
- INSPECT COMBINATION METER ASSEMBLY
- Inspect the combination meter (See HOW TO PROCEED WITH TROUBLESHOOTING ).
NG : REPLACE COMBINATION METER ASSEMBLY (See REMOVAL )
OK : REPLACE BRAKE ACTUATOR ASSEMBLY (See REMOVAL )