Transmission Wire: Installation

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring of the transmission wire connector with ATF WS and install it to the transmission wire.
  
  Fig 1: Locating O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission wire with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the transmission wire connector.
Fig 2: Locating Transmission Wire Connector And Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE
1. Coat the O-ring of the ATF temperature sensor with ATF WS.
2. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
3. Connect the transmission wire to the 7 shift solenoid valve connectors.
Fig 3: Locating Shift Solenoid Valve Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
1. Install the 2 magnets in the oil pan.
2. Apply adhesive or equivalent to 18 bolts.
  Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  Fig 4: Identifying Oil Pan Magnets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  
  NOTE: Since the bolts are seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.
  
  Fig 5: Locating Oil Pan Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (See INSTALLATION )
INSTALL BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
INSTALL ENGINE UNDER COVER LH
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL (See AUTOMATIC TRANSAXLE FLUID )