Data List / Active Test

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY

Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Check the values by referring to the table below.

Data List

TESTER DISPLAY NORMAL CONDITION CHART

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Driver Seat Position	Driver seat position/ Forward: Seat position is forward Bkward: Seat position is backward FAIL: Failure detected	Forward/Bkward	-
Passenger Classification	Passenger classification/ NG: Data is not determined OFF: Vacant CHILD: Child (less than 36 kg (79.3 lb)) is seated AF05: Adult (36 to 54 kg (79.3 to 119.0 lb) is seated AM50: Adult (more than 54 kg (119.01b)) is seated	OFF/CHILD/AF05/AM50	-
Left Side Buckle SW	Left side buckle switch/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined	Unset/Set	-
Right Side Buckle SW	Right side buckle switch/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined	Unset/Set	-
Number of Past DTC	Number of past DTC/ Min.: 0, Max.: 255	0	-
Display Type Information	Display type information/ LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger	LR	-