LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Automatic Transmission - U341E) >> Park / Neutral Position Switch >> Removal

Park / Neutral Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE BATTERY  (See REMOVAL )
  2. REMOVE BATTERY CARRIER  (See REMOVAL )
  3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Remove the nut and disconnect the control cable assembly from the control shaft lever.
      Fig 1: Locating Control Shaft Lever Nut
      G06011536Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip and disconnect the control cable assembly from the control cable bracket.
  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
  1. Disconnect the connector from the park/neutral position switch assembly.
  2. Remove the nut, washer and control shaft lever.
    Fig 2: Locating Control Shaft Lever
    G04831093Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Unstake the lock plate and remove the manual valve shaft nut.
    Fig 3: Removing Manual Valve Shaft Nut
    G04831094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. Remove the 2 bolts and pull out the park/neutral position switch assembly.
Fig 4: Locating Park/Neutral Position Switch Bolts
G04831095Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals