LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - U250E) >> Speed Sensor >> Removal

Speed Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE AIR CLEANER CASE  (See REMOVAL )
  5. REMOVE BATTERY  (See REMOVAL )
  6. REMOVE BATTERY CARRIER  (See REMOVAL )
  7. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY 
    1. Remove the transmission oil level gauge sub-assembly.
    2. Disconnect the transmission wire connector, park/neutral position switch connector and 2 wire harness clamps.
    3. Remove the bolt and transmission oil filler tube sub-assembly.
    4. Remove the O-ring from the transmission oil filler tube sub-assembly.
    Fig 1: Locating Wire Harness Clamps
    G06011428Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE SPEED SENSOR NT 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
    3. Remove the O-ring from the speed sensor.
    Fig 2: Locating Speed Sensor NT And Bolt
    G06011429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE SPEED SENSOR NC 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
    3. Remove the O-ring from the speed sensor.
    Fig 3: Locating Speed Sensor NC And Bolt
    G04975916Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals