Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL SPEED SENSOR NC
1. Coat a new O-ring with ATF WS and install it to the speed sensor.
  
  Fig 1: Identifying Speed Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the speed sensor with the bolt.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
3. Connect the speed sensor connector.
INSTALL SPEED SENSOR NT
1. Coat a new O-ring with ATF WS and install it to the speed sensor.
  
  Fig 2: Locating Speed Sensor NC And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the speed sensor with the bolt.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
3. Connect the speed sensor connector.
INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
1. Apply ATF to a new O-ring, and install it to the transmission oil filler tube sub-assembly.
  
  Fig 3: Locating Speed Sensor NT And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission oil filler tube sub-assembly to the automatic transaxle with the bolt.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
3. Connect the transmission wire connector, park/neutral position switch connector and 2 wire harness clamps.
4. Install the transmission oil level gauge sub-assembly to the transmission oil filler tube sub-assembly.
Fig 4: Locating Wire Harness Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
INSTALL AIR CLEANER CASE (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )