LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - U140F) >> Park / Neutral Position Switch >> Removal

Park / Neutral Position Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE BATTERY  (See REMOVAL )
  3. REMOVE BATTERY CARRIER  (See REMOVAL )
  4. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Remove the nut and disconnect the control cable assembly from the control shaft lever.
    2. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.
    Fig 1: Locating Control Shaft Lever Nut
    G06041058Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Disconnect the park/neutral position switch connector.
      Fig 2: Identifying Park/Neutral Position Switch Connector
      G06043183Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut, washer and control shaft lever.
      Fig 3: Locating Control Shaft Lever, Washer And Nut
      G05388035Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a screwdriver, unstake the lock plate.
    4. Remove the nut and lock plate.
      Fig 4: Removing Lock Plate Nut
      G05388036Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the 2 bolts and pull out the switch.
    Fig 5: Locating Switch Bolt
    G05388037Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals