LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Air Conditioning (Service Information)) >> Blower Unit >> Installation (To 12/2010) >> Installation

Installation (To 12/2010): Installation

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL AIR CONDITIONING UNIT ASSEMBLY  See step  1
  2. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY  See step  2
  3. INSTALL REAR NO. 2 AIR DUCT  See step  3
  4. INSTALL REAR NO. 1 AIR DUCT  See step  4
  5. INSTALL FLOOR CARPET BRACKET LH  See step  5
  6. INSTALL FLOOR CARPET BRACKET RH  See step  6
  7. INSTALL NO. 1 CONSOLE BOX DUCT  See step  7
  8. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY  See step  8
  9. INSTALL NO. 2 HEATER TO REGISTER DUCT  See step  9
  10. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 
    1. Install the instrument panel safety pad sub-assembly. Refer to INSTALLATION .
  11. INSTALL STEERING COLUMN ASSEMBLY 
    1. Install the steering column assembly. Refer to INSTALLATION .
  12. CONNECT INLET HEATER WATER HOSE  See step  12
  13. CONNECT OUTLET HEATER WATER HOSE  See step  13
  14. INSTALL AIR CONDITIONER TUBE AND ACCESSORY  See step  14
  15. INSTALL SUCTION HOSE SUB-ASSEMBLY  See step  15
  16. INSTALL COWL TOP PANEL OUTER  See step  16
  17. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  . Refer to INSTALLATION - Step 2
  18. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  See step  18
  19. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  . Refer to INSTALLATION - Step 3
  20. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  . Refer to INSTALLATION - Step 4
  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  22. ADD ENGINE COOLANT  . Refer to REPLACEMENT - Step 2
  23. CHARGE REFRIGERANT  See step  2
  24. WARM UP ENGINE  See step  3
  25. INSPECT FOR REFRIGERANT LEAK  See step  4
  26. CHECK FOR ENGINE COOLANT LEAKS  . Refer to REPLACEMENT - Step 3
  27. INITIALIZE SERVO MOTOR 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to on.
    4. Press the A/C OFF switch.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
    7. According to the Techstream display, select the "Next" switch.
    8. According to the Techstream display, select the "Next" switch.

      HINT: 

      During initialization, the DEF indicator blinks. When initialization is complete, the indicator turns off.

    9. According to the Techstream display, select the exit to finish the initialization.
scientia non olet · About LEMON Manuals