LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Combination Meter (Service Information)) >> Combination Meter >> REMOVAL (To 12/2010) >> Removal

REMOVAL (To 12/2010): Removal

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  2. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL  . Refer to REMOVAL - Step 10
  3. REMOVE INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)  . Refer to REMOVAL - Step 15
  4. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 16
  5. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 17
  6. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 4 screws.
      Fig 1: Identifying Combination Meter Assembly Screws
      GTY301089Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector and remove the combination meter assembly.
scientia non olet · About LEMON Manuals