On-Vehicle Inspection
- INSPECT STARTER RELAY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard Resistance
RESISTANCE SPECIFIED CONDITIONTester Connection Condition Specified Condition 3 - 5 Battery voltage is not applied to terminals 1 and 2. 10 kΩ or higher 3 - 5 Battery voltage is applied to terminals 1 and 2. Below 1 Ω If the result is not as specified, replace the relay.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the resistance.
- INSPECT ACC RELAY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard Resistance
RESISTANCE SPECIFIED CONDITIONTester Connection Condition Specified Condition 3 - 5 Battery voltage is not applied to terminals 1 and 2. 10 kΩ or higher 3 - 5 Battery voltage is applied to terminals 1 and 2. Below 1 Ω If the result is not as specified, replace the relay.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the resistance.
- INSPECT ACC CUT RELAY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard Resistance
RESISTANCE SPECIFIED CONDITIONTester Connection Condition Specified Condition 3 - 4 Battery voltage is not applied to terminals 1 and 2. Below 1 Ω 3 - 4 Battery voltage is applied to terminals 1 and 2. 10 kΩ or higher 3 - 5 Battery voltage is not applied to terminals 1 and 2. 10 kΩ or higher 3 - 5 Battery voltage is applied to terminals 1 and 2. Below 1 Ω Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the relay.
- Using an ohmmeter, measure the resistance between the terminals.
- Check the resistance.