LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Matrix Base, Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Rear Airbag Sensor >> Removal

Rear Airbag Sensor: Removal

HINT:

  1. PRECAUTION 
    CAUTION: Be sure to read Precaution thoroughly before servicing (See PRECAUTION ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  3. REMOVE REAR DOOR SCUFF PLATE  (See REMOVAL )
  4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP  (See REMOVAL )
  5. REMOVE REAR SEAT CUSHION ASSEMBLY  (See REMOVAL )
  6. REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side) 
  7. REMOVE REAR SEATBACK OUTER HINGE COVER (for LH Side)  (See REMOVAL )
  8. REMOVE REAR SEATBACK INNER HINGE COVER (for LH Side)  (See REMOVAL )
  9. REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side)  (See REMOVAL )
  10. REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side) 
  11. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side) 
  12. DISCONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY (for RH Side)  (See REMOVAL )
  13. REMOVE REAR SEATBACK OUTER HINGE COVER (for RH Side)  (See REMOVAL )
  14. REMOVE REAR SEATBACK INNER HINGE COVER (for RH Side)  (See REMOVAL )
  15. REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side)  (See DISASSEMBLY )
  16. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY  (See REMOVAL )
  17. REMOVE REAR SEAT SIDE GARNISH 

    for LH Side: (See REMOVAL )

    for RH Side: (See REMOVAL )

  18. REMOVE REAR AIRBAG SENSOR 
    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    3. Disconnect the connector from the rear airbag sensor.
      NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.
    4. Remove the nut and disengage the pin, and remove the rear airbag sensor.
    NOTE: Loosen the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
    Fig 1: Locating Rear Airbag Sensor Nut
    G06037078Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002