Front Stabilizer Bar: Inspection

INSPECT FRONT STABILIZER LINK ASSEMBLY RH
1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.
  Standard turning torque:
  
  0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)
  
  If the value is not within the specified range, replace the front stabilizer link with a new one.
  
  Fig 1: Inspecting Front Stabilizer Link Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Check the dust boot for cracks or grease leakage.