Front Shock Absorber: Disposal

DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
1. Set the front shock absorber assembly on its side.
2. Fully extend the shock absorber rod.
3. Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.
  CAUTION: Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.
  
  NOTE: The gas is colorless, odorless and nonpoisonous.
  
  Fig 1: Identifying Cylinder Drilling Hole Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002