Inspection Procedure

1. Select the Active Test, use the Techstream to generate a control command, and then check that each power window regulator motor operates (See DATA LIST/ACTIVE TEST  ).
   CAUTION: Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.

   D-Door Motor 

   D-DOOR MOTOR CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range
   Power Window	Driver side power window	OFF/UP/DOWN

   P-Door Motor 

   P-DOOR MOTOR CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range
   Power Window	Front passenger side power window	OFF/UP/DOWN

   RL-Door Motor 

   RL-DOOR MOTOR CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range
   Power Window	Rear LH side power window	OFF/UP/DOWN

   RR-Door Motor 

   RR-DOOR MOTOR CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range
   Power Window	Rear RH side power window	OFF/UP/DOWN

   OK: Each power window motor operates. 

   Result 

   DTC RESULT REFERENCE
   
   

   Result	Proceed To
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

D: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

E: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

A: Go to Next Step 

1. Initialize the power window regulator motor (See INITIALIZATION  ).
2. Check that each power window operates normally by opening and closing the window (See OPERATION CHECK  ).

   OK: Each power window operates normally. 

   Result 

   DTC RESULT REFERENCE
   
   

   Result	Proceed To
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

D: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

E: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

A: Go to Next Step 

1. Check that the power window components are installed correctly.

   OK: Power window components are installed correctly. 

   HINT:

   When the power window components are installed correctly, the problem has been caused by battery disconnection while the engine switch is on (IG) or the motor being overheated.

NG: INSTALL PARTS CORRECTLY 

OK: END