LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock >> Wireless Door Lock Control System >> Data List/Active Test

Data List/Active Test

  1. READ DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical/Main Body/Data List.
    5. According to the display on the Techstream, read the Data List.

    Main Body 

    DIAGNOSTIC NOTE CHART

    Tester Display Measurement Item/Range Normal Condition
    D Door Courtesy SW Driver side door courtesy switch signal/ON or OFF ON: Driver side door is open
    OFF: Driver side door is closed
    P Door Courtesy SW Passenger side door courtesy switch signal/ON or OFF ON: Passenger side door is open
    OFF: Passenger side door is closed
    RL Door Courtesy SW Rear door courtesy switch LH signal/ON or OFF ON: Rear side door LH is open
    OFF: Rear side door LH is closed
    RR Door Courtesy SW Rear door courtesy switch RH signal/ON or OFF ON: Rear side door RH is open
    OFF: Rear side door RH is closed
    Back Door Courtesy SW Back door courtesy switch signal/ON or OFF ON: Back door is open
    OFF: Back door is closed
    D Lock Pos switch Driver side door lock position switch signal/ON or OFF ON: Driver side door lock is unlocked
    OFF: Driver side door lock is locked
    P Lock Pos switch Passenger side door lock position switch signal/ON or OFF ON: Passenger side door is unlocked
    OFF: Passenger side door is locked
    RL Lock Pos switch Rear door LH lock position switch signal/ON or OFF ON: Rear side door LH is unlocked
    OFF: Rear side door LH is locked
    RR Lock Pos switch Rear door RH lock position switch signal/ON or OFF ON: Rear side door RH is unlocked
    OFF: Rear side door RH is locked
    Back Lock Pos switch Back door lock position switch signal/ON or OFF ON: Back door is unlocked
    OFF: Back door is locked
  2. ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical/Main Body/Active Test.
    5. According to the display on the Techstream, perform the Active Test.

    Main Body 

    DIAGNOSTIC NOTE CHART

    Tester Display Test Part Control Range
    Hazard Turn signal flasher relay ON or OFF
    Door Lock All door lock motors OFF or LOCK
    D-Door Unlock Driver side door unlock motor OFF or UNLOCK
scientia non olet · About LEMON Manuals