Door Control Switch: Inspection

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Switch Condition	Specified Condition
   2 (L) - 3 (E)	Unlock	Below 1 Ω
   2 (L) - 3 (E)	Off	10 kΩ or higher
   4 (UL) - 3 (E)
   4 (UL) - 3 (E)	Lock	Below 1 Ω

   Fig 1: Inspecting Door Control Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   If the result is not as specified, replace the control switch assembly.

2. Apply battery voltage to the switch connector and check that the indicator (LED) illumination condition.

OK 

Fig 2: Identifying Door Control Switch Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the door control switch assembly.