Door Control Receiver: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

Fig 1: Locating Door Control Receiver Bolt & Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL DOOR CONTROL RECEIVER 
   1. Install the receiver with the bolt.

      Torque: 15 N.m (153 kgf*cm, 11 ft.*lbf) 

   Fig 2: Locating Receiver With Bolt
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Connect the connector.
2. INSTALL REAR UPPER PILLAR GARNISH RH  (See INSTALLATION )
3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH  (See INSTALLATION )
4. INSTALL REAR SEAT COVER CAP  (See INSTALLATION )
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK  (See INSTALLATION )
6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE  (See INSTALLATION )
7. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
8. INSTALL REAR STEP COVER  (See INSTALLATION )
9. INSTALL REAR NO. 2 SEAT ASSEMBLY RH 
   1. Install the rear No. 2 seat assembly RH (See INSTALLATION ).