Inspection Procedure

1. Check if the "Bluetooth" settings are correct.

   OK: "Bluetooth" settings are correct. 

   NG: SET SETTINGS CORRECTLY 

   OK: Go to Next Step 

1. Check if the cellular phone is "Bluetooth" compatible.

   HINT:

   Some versions of "Bluetooth" compatible cellular phones may not function.

   OK: Phone is "Bluetooth" compatible. 

   NG: END (ONLY A "BLUETOOTH" COMPATIBLE CELLULAR PHONE CAN BE USED) 

   OK: Go to Next Step 

1. Check if the cellular phone functions.

   HINT:

   The cellular phone is unable to call under any of the following conditions.

   • The cellular phone is locked.
   • The directory is being transferred.
   • The line is crossed.
   • Transmission is regulated.
   • The power is OFF.
   • The cellular phone is not connected to "Bluetooth" ("Bluetooth" mark is displayed while connected).

     OK: Above conditions do not exist. 

   NG: SET CORRECTLY 

   OK: Go to Next Step 

1. Check if the cellular phone can make calls.

   HINT:

   When the battery is low, calls cannot be made or received.

   OK: Cellular phone can make calls. 

   NG: REPLACE CELLULAR PHONE 

   OK: Go to Next Step 

1. Set the cellular phone so that it can receive calls.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.

   OK: Cellular phone has reception. 

NG: REPLACE MULTI-DISPLAY  (See MULTI-DISPLAY (W/NAVIGATION SYSTEM)  )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )