General Maintenance

HINT:

Perform these procedures after the engine has cooled down.

1. INSPECT DRIVE BELT 
   DRIVE BELT REFERENCE
   
   

   Type	See procedure
   2GR-FE	See INSPECTION
   1AR-FE	See ON-VEHICLE INSPECTION

2. INSPECT SPARK PLUGS 
   SPARK PLUGS REFERENCE
   
   

   Type	See procedure
   2GR-FE	See ON-VEHICLE INSPECTION
   1AR-FE	See ON-VEHICLE INSPECTION

3. INSPECT BATTERY 
   BATTERY REFERENCE
   
   

   Type	See procedure
   2GR-FE	See ON-VEHICLE INSPECTION
   1AR-FE	See ON-VEHICLE INSPECTION

4. INSPECT AIR CLEANER FILTER 
   1. Remove the air filter.
   2. Visually check that the air filter is not excessively damaged or oily.

      HINT:

      Oiliness may indicate that the PCV valve is stuck. If necessary, replace the air filter.

   3. Reinstall the air filter.
5. REPLACE AIR CLEANER FILTER 
   1. Replace the air filter with a new one.
   Fig 1: Cleaning Air Cleaner Filter

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REPLACE ENGINE OIL AND OIL FILTER 
   ENGINE OIL AND OIL FILTER REFERENCE
   
   

   Type	See procedure
   2GR-FE	See REPLACEMENT
   1AR-FE	See REPLACEMENT

7. REPLACE ENGINE COOLANT 
   ENGINE COOLANT REFERENCE
   
   

   Type	See procedure
   2GR-FE	See COOLANT
   1AR-FE	See COOLANT

8. INSPECT GASKET IN FUEL TANK CAP 
   FUEL TANK CAP REFERENCE
   
   

   Type	See procedure
   2GR-FE	See FUEL TANK CAP
   1AR-FE	See FUEL TANK CAP

9. INSPECT FUEL LINES AND CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES 
   1. Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.
10. INSPECT EXHAUST PIPES AND MOUNTINGS 
    1. Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
11. INSPECT CHARCOAL CANISTER