LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Hybrid) - SFI System Diagnostic Introduction, Diagnostic Trouble Code Chart >> SFI System >> Inspection Mode Procedure

Inspection Mode Procedure

HINT:

Before reading the Data List or performing the Active Tests using the Techstream, be sure to put the system into inspection mode using the following procedure.

  1. ACTIVATING INSPECTION MODE 
    1. Perform the following steps (1) through (4) in 60 seconds.
      1. Turn the power switch on (IG).
      2. Fully depress the accelerator pedal twice with the transmission in the P position.
      3. Fully depress the accelerator pedal twice with the transmission in the N position.
      4. Fully depress the accelerator pedal twice with the transmission in the P position.
      5. Check that "FWD MAINTENANCE MODE" is displayed on the multi-information display and the master warning light is illuminated in the combination meter.
      6. Turn the power switch on (READY).
scientia non olet · About LEMON Manuals