LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Base, 2.7 A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1AR-FE) - Circuit Testing, Component Inspection, Removal & Installation >> Crankshaft Position Sensor >> Inspection

Crankshaft Position Sensor: Inspection

  1. INSPECT CRANKSHAFT POSITION SENSOR 
    1. Measure the resistance according to the value (s) in the table below.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      1-2 Cold 1630 to 2740 Ω
      Hot 2065 to 3225 Ω

      HINT:

      In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F). If the result is not as specified, replace the crankshaft position sensor.

      Fig 1: Identifying Crankshaft Position Sensor Connector
      G06111309Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals