Starting System: Starter: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
1. Remove the 4 bolts, then remove the No. 2 engine under cover assembly.
REMOVE NO. 2 EXHAUST MANIFOLD STAY
1. Remove the 3 bolts, then remove the No. 2 manifold stay.
  
  Fig 1: Identifying No. 2 Exhaust Manifold Stay Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE WIRE HARNESS
1. Remove the bolt, then separate the earth wire harness from the cylinder block.
  
  Fig 2: Identifying Earth Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STARTER ASSEMBLY
1. Disconnect the terminal 50 connector from the starter assembly.
2. Remove the nut, then disconnect the wire harness from the terminal 30.
  
  Fig 3: Identifying Wire Harness & Starter Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 2 bolts, then remove the starter assembly.
  
  Fig 4: Identifying Starter Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002