Valve Body Assembly: Installation

1. Insert the pin of the lever into the hole of the manual valve.
Fig 1: Identifying Pin Of Lever
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install 3 new drum seal gaskets onto the transmission case.
3. Install the 19 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   HINT:

   Bolt length:

   36 mm (1.42 in.) for bolt A

   25 mm (0.98 in.) for bolt B

   Fig 2: Identifying Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the 7 connectors to the solenoid valves.
2. Install the 2 clamps with the 2 bolts.

   Torque: 

   10 N*m (100 kgf*cm, 7 in.*lbf) for bolt A 

   11 N*m (112 kgf*cm, 8 ft.*lbf) for bolt B 

   Bolt length: 

   12 mm (0.47 in.) for bolt A 

   36 mm (1.42 in.) for bolt B 

   Fig 3: Identifying Clamps With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the ATF temperature sensor.

1. Install a new O-ring and the oil strainer with the 4 bolts.

   Torque: 10 N*m (100 kgf*cm, 7 ft.*lbf) 

   Fig 4: Identifying Oil Strainer Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

1. Install a new gasket and the oil pan with the 20 bolts.

   Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

   Fig 5: Removing/Installing Oil Pan Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

   Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

(See INITIALIZATION  )

(See ADJUSTMENT  )