LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> FJ Cruiser 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer >> Engine Immobilizer System >> DTC Check / Clear

DTC Check / Clear

  1. CHECK FOR IMMOBILIZER DTC 
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body Electrical / Immobilizer / Trouble Codes.
    5. Read the DTCs.

      HINT:

      • When using Techstream with the ignition switch LOCK to troubleshoot: Connect the Techstream to the vehicle, and turn the front door courtesy light switch LH on and off at 1.5 second intervals until communication between the tester and vehicle begins.
      • Refer to the Techstream operator's manual for further details.
  2. CHECK FOR ECM DTC 
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    5. Read the DTCs.
  3. CLEAR FOR IMMOBILIZER DTC 
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body Electrical / Immobilizer / Trouble Codes.
    5. Erase the DTCs.

      HINT:

      • When using Techstream with the ignition switch LOCK to troubleshoot: Connect the Techstream to the vehicle, and turn the front door courtesy light switch LH on and off at 1.5 second intervals until communication between the tester and vehicle begins.
      • Refer to the Techstream operator's manual for further details.
  4. CLEAR FOR ECM DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    5. Erase the DTCs.
scientia non olet · About LEMON Manuals