Power Window Regulator Motor: Removal

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure described below is for the RH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE FRONT ARMREST BASE UPPER PANEL  (See DISASSEMBLY )
3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
4. REMOVE FRONT NO. 2 DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
5. REMOVE OUTER REAR VIEW MIRROR  (See REMOVAL )
6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY  (See REMOVAL )
7. REMOVE FRONT NO. 1 SPEAKER  (See REMOVAL )
8. REMOVE FRONT DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
9. REMOVE FRONT DOOR INSIDE PANEL PLATE  (See DISASSEMBLY )
10. REMOVE FRONT DOOR CHECK ASSEMBLY  (See DISASSEMBLY )
11. REMOVE FRONT DOOR WEATHERSTRIP  (See DISASSEMBLY )
12. REMOVE FRONT DOOR GLASS RUN  (See DISASSEMBLY )
13. REMOVE FRONT DOOR FRAME SUB-ASSEMBLY FRONT LOWER  (See DISASSEMBLY )
14. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH  (See DISASSEMBLY )
15. REMOVE FRONT DOOR WINDOW FRAME REAR LOWER  (See DISASSEMBLY )
16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
17. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY  (See DISASSEMBLY )
18. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY 
    1. Using "Torx" socket wrench T25, remove the 3 screws and the power window regulator motor.
       Fig 1: Identifying Power Window Regulator Motor Assembly

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002