LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla Base, 1.8 L, Standard >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Lock System >> DTC B2781 Open / Short in Steering Lock ECU >> Inspection Procedure

Inspection Procedure

HINT:

When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following step to wake up the ECU:

Before starting the inspection, open the driver door with the engine switch off. Then (with the engine switch still off) open and close any door several times at 1.5-second intervals.

NOTE: If the steering lock actuator (steering lock ECU) is replaced, open and close the driver side door with the engine switch off and the shift lever in neutral to record the current lock position into the steering lock ECU. If this is not performed, the engine may not start.
  1. REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) 

    HINT:

    The steering lock ECU and steering lock actuator assembly are supplied as a unit.

    1. Replace the steering lock actuator assembly (See DISASSEMBLY ).

    NEXT: END 

scientia non olet · About LEMON Manuals