LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Hybrid >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control - Hybrid >> Skid Control Sensor >> Inspection

Skid Control Sensor: Inspection

  1. INSPECT SKID CONTROL SENSOR 
    1. Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:
      • The surface of the skid control sensor is cracked, dented, or chipped off.
      • The connector is scratched, cracked, or damaged.
      • The skid control sensor has been dropped.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance LH 

      RESISTANCE REFERENCE

      Tester Connection Condition Tester Connection
      2 (RL+) - 1 (RL-) Always Below 1.45 kΩ at 20°C (68°F)
      2 (RL+) - Body ground Always 10 kΩ or higher
      1 (RL-) - Body ground Always 10 kΩ or higher
      Fig 1: View Of Rear Speed Sensor Resistance
      G04978029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      RH 

      RESISTANCE REFERENCE

      Tester Connection Condition Tester Connection
      2 (RR+) - 1 (RR-) Always Below 1.45 kΩ at 20°C (68°F)
      2 (RR+) - Body ground Always 10 kΩ or higher
      1 (RR-) - Body ground Always 10 kΩ or higher

      If the value is not as specified, replace the skid control sensor.

scientia non olet · About LEMON Manuals