LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Camry Hybrid >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control - Hybrid >> Electronically Controlled Brake System >> DTC 36 ABS Control System Malfunction; DTC 43 ABS Control System Malfunction >> Inspection Procedure

Inspection Procedure

NOTE: When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (See INITIALIZATION ).
  1. CHECK ABS CONTROL SYSTEM 
    1. Clear the DTC (See DTC CHECK / CLEAR ).
    2. Turn the power switch on (IG).
    3. Check if the same DTC is recorded (See DTC CHECK / CLEAR ).

    Result 

    DTC RESULT REFERENCE

    Condition Proceed to
    DTC (ABS control system DTC) is not output A
    DTC (ABS control system DTC) is output B

    B: REPAIR CIRCUIT INDICATED BY OUTPUT DTC  (See DIAGNOSTIC TROUBLE CODE CHART )

    A: GO to next step 

  2. RECONFIRM DTC 
    1. Turn the power switch off.
    2. Clear the DTC (See DTC CHECK / CLEAR ).
    3. Turn the power switch on (IG).
    4. Check if the same DTC is recorded (See DTC CHECK / CLEAR ).

    Result 

    DTC RESULT REFERENCE

    Condition Proceed to
    DTCs (36 and/or 43) are not output A
    DTCs (36 and/or 43) are output B

    B: REPLACE SKID CONTROL ECU 

    A: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) 

scientia non olet · About LEMON Manuals