Brake Control Power Supply: Installation

INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
1. Install the No. 2 brake control power supply bracket with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Locating Brake Control Power Supply Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the No. 2 brake control power supply bracket with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL BRAKE CONTROL POWER SUPPLY WITH BRACKET
1. Install the brake control power supply with bracket with the 3 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Locating Brake Control Power Supply Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the brake control power supply connector and install the clamp.
INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH (See INSTALLATION )
INSTALL LUGGAGE TRIM SERVICE HOLE COVER (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT REAR TRIM COVER (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT TRIM HOOK NO. 1 (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CLEAR DTC FOR BRAKE CONTROL SYSTEM
HINT:

Refer the procedures up to "ELECTRONICALLY CONTROLLED BRAKE SYSTEM". (See DTC CHECK / CLEAR )
PERFORM INITIALIZATION
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal. (See INITIALIZATION )