Inspection Procedure

CHECK WIRE HARNESS (POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND)

Fig 1: Identifying K1 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage according to the value (s) in the table below.
Standard voltage

VOLTAGE SPECIFICATION

Tester Connection	Condition	Specified Condition
3 (B) - Body ground	Power switch on (IG)	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE