Data List / Active Test
- USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Monitor the ECU data by following the prompts on the tester screen.
HINT:
The Techstream has a "Snapshot" function which records the monitored data. Refer to the Techstream operator's service information for further details.
- DATA LIST
HINT:
Using the DATA LIST displayed on the Techstream, the value of the switches, sensors, actuators, etc. can be read without part removal. Reading the DATA LIST as the first step in troubleshooting is one way to shorten the labor time.
- Connect the Techstream to the DLC3.
- Turn the ignition switch on (IG).
- Read the DATA LIST according to the display on the tester.
D DOOR MOTOR:
D DOOR MOTORTester Display Measurement Hem/Range Normal Condition Diagnostic Note D P/W AUTO SW Driver door power window auto switch signal/ON or OFF ON: Driver door power window auto switch operates
OFF: Driver door power window auto switch does not operate- P P/W AUTO SW Front passenger door remote power window auto switch signal/ ON or OFF ON: Front passenger door remote power window auto switch operates
OFF: Front passenger door remote power window auto switch does not operate- D P/W DOWN SW Driver door power window manual down switch signal/ON or OFF ON: Driver door power window manual down switch operate
OFF: Driver door power window manual down switch does not operate- Main Body:
MAIN BODYTester Display Measurement Item/Range Normal Condition Diagnostic Note Communication Master SW Master switch communication signal OK/STOP OK: Communication is normal
STOP: Communication is stop- Ignition Switch Ignition switch signal/ON or OFF ON: Power source mode is (IG)
OFF: Power source mode is off or on (ACC)- D Door Courtesy SW Driver side door courtesy switch signal/ON or OFF ON: Driver side door is open
OFF: Driver side door is closed- P Door Courtesy SW Front passenger side door courtesy switch signal/ON or OFF ON: Front passenger side door is open
OFF: Front passenger side door is closed- - ACTIVE TEST
HINT:
Performing the ACTIVE TEST using the Techstream allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten the labor time. It is possible to display the DATA LIST during the ACTIVE TEST.
- Connect the Techstream to the DLC3.
- Turn the ignition switch on (IG).
- Perform the ACTIVE TEST according to the display on the tester.
D DOOR MOTOR:
D DOOR MOTORTester Display Measurement Hem/Range Normal Condition POWER WINDOW Operates power window UP/DOWN - Main Body:
MAIN BODYTester Display Measurement Item/Range Normal Condition IG OFF P/W Control Permission Output Operates power window ON/OFF (After ignition OFF) -