Inspection Procedure

CHECK WIRE HARNESS (POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND)

Disconnect the J1 connector.

Fig 1: Identifying J1 Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Measure the voltage according to the value(s) in the table below.

Standard voltage

POWER WINDOW REGULATOR SWITCH - BATTERY AND BODY GROUND

Tester Connection	Condition	Specified Condition
3 (B) - Body ground	Ignition switch on (IG)	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE