Automatic Transmission - U660E: TCM: Installation

INSTALL TCM
1. Install the TCM to the automatic transaxle assembly.
  
  Fig 1: Installing TCM Of Automatic Transaxle Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install and tighten the 2 bolts in the order shown in the illustration.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Fig 2: Installing Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector to the TCM.
4. Turn the lock lever and secure the connector with the lock lever.
INSTALL INTAKE AIR RESONATOR SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL NO. 2 AIR CLEANER INLET (See INSTALLATION )
INSTALL BATTERY
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
PERFORM TCM REGISTRATION
HINT:

See REGISTRATION .
PERFORM INITIALIZATION
1. Perform initialization procedure (IN-33).
  NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.
  
  Fig 3: Connecting Connector To TCM
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002