LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Avalon XLS >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front Lower Ball Joint >> Installation

Front Lower Ball Joint: Installation

  1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH 
    1. Install the lower ball joint assembly front LH to the steering knuckle with the castle nut.

      Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) 

    2. Install a new cotter pin to the steering knuckle.
      NOTE: Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
  2. INSTALL FRONT AXLE ASSEMBLY LH 
    1. Install the front axle assembly LH (See INSTALLATION ).
  3. INSTALL FRONT LOWER SUSPENSION ARM 
    1. Install the front lower suspension arm (See REMOVAL  ).
  4. INSTALL TIE ROD ASSEMBLY LH 
    1. Install the tie rod assembly LH (See INSTALLATION ).
  5. INSTALL DISC WHEEL 
  6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH 
    1. Install the front disc brake caliper assembly LH (See INSTALLATION ).
  7. INSTALL SPEED SENSOR FRONT LH 
    1. Install the speed sensor front LH (See INSTALLATION ).
  8. INSTALL FRONT AXLE SHAFT LH NUT 
    1. Install the front axle hub LH nut (See INSTALLATION ).
  9. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

  10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 
    1. Inspect and adjust the front wheel alignment (See ADJUSTMENT  ).
  11. INSPECT ABS SPEED SENSOR SIGNAL 

    with VSC (See TEST MODE PROCEDURE )

scientia non olet · About LEMON Manuals