Inspection Procedure

1. Measure the voltage according to the value(s) in the table below.

   Voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection (Symbols)	Condition	Specified Condition
   D14-4 (SLP1) - D14-2 (SGND)	Engine switch off Turn the engine switch on (ACC or IG)	Below 1 V

OK : CHECK PUSH BUTTON START SYSTEM 

Fig 1: Identifying D14 Steering Lock Actuator Assembly Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: Go to next step 

1. Disconnect the D14 connector from the steering lock actuator assembly.
   Fig 2: Identifying D14 Steering Lock Actuator Assembly Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the D44 connector from the power source control ECU.
3. Measure the resistance according to the value(s) in the table below.

   Resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection (Symbols)	Condition	Specified Condition
   D14-4 (SLP1) - D44-26 (SLP)	Always	Below 1 Ω
   D14-4 (SLP1) - Body ground	Always	10 kΩ or higher

   Fig 3: Identifying D44 Power Source Control ECU Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : REPLACE STEERING LOCK ACTUATOR ASSEMBLY