Inspection Procedure

1. Disconnect the D14 connector from the steering lock actuator assembly.
2. Measure the resistance according to the value(s) in the table below.

   Resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester connection (Symbols)	Condition	Specified condition
   D14-1 (GND) - Body ground	Always	Below 1 Ω.
   D14-2 (SGND) - Body ground	Always	Below 1 Ω.

   Fig 1: Identifying D14 Steering Lock Actuator Assembly Connector - Body Ground

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the voltage according to the value(s) in the table below.

   Voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester connection (Symbols)	Condition	Specified condition
   D14-7 (B) - D14-1 (GND)	Always	10 to 14 V
   D14-7 (B) - D14-2 (SGND)	Always	10 to 14 V

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

Fig 2: Identifying D14 Steering Lock Actuator Assembly Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY BATTERY)