Blower Unit: Reassembly

INSTALL COOLER EVAPORATOR SUB-ASSEMBLY NO.1
1. sufficiently apply compressor oil (ND-OIL 8) to 2 new O-rings and the fitting surface. Install the 2 O-rings to the cooler evaporator No.1.
  Compressor oil:
  
  ND-OIL 8 or equivalent
  
  Fig 1: Identifying O-Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOLER EXPANSION VALVE
1. Using a hexagon wrench 4 mm, install the cooler expansion valve with the 2 hexagon bolts.
  Torque: 3.5 N*m (35 kgf*cm, 30 in.*lbf)
  
  Fig 2: Identifying Cooler Expansion Valve With Hexagon Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL EVAPORATOR TEMPERATURE SENSOR
1. If using a mew evaporator:
  Install the sensor to the evaporator as shown in the illustration.
  
  Fig 3: Identifying Evaporator Temperature Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. If reusing the evaporator:
  1. Install the sensor to the evaporator as shown in the illustration.
    HINT:
    
    Completely cover the tube with the grommet.
    
    Fig 4: Identifying Sensor To Evaporator
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002