Inspection Procedure

1. Disconnect the connector from heater control panel LH.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage 

   STANDARD VOLTAGE SPECIFICATIONS
   
   

   Tester Connection	Condition	Specified Condition
   E6-1 (IG+) - Body ground	Ignition switch on (IG)	10 to 14 V
   E6-1 (IG+) - Body ground	Ignition switch off	Below 1 V

   Fig 1: Identifying E6 Heater Control Panel LH (IG+ - Body Ground)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   OK	A
   NG (w/o Smart key system)	B
   NG (w/ Smart key system)	C

B:  Go to STARTING SYSTEM

C:  Go to PUSH BUTTON START SYSTEM.

A: Go to Next Step 

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATIONS
   
   

   Tester Connection	Condition	Specified Condition
   E6-24 (GND) - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Identifying E6 Heater Control Panel LH (GUD - Body Ground)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE